Model		LXL-25F	LXH-35F	LXH-50F	LXH-70F	LXH-90F	LXH-120F
Power Supply(V~PH~Hz)		220V~50Hz 380V~3PH~50Hz				380V~3PH~50Hz
Nominal Capacity(W)		2700	3750	5270	7200	11350	14940
Cooling Capacity(M³)		1	1.5	2	3	4	5
Input Power(W)		950	1300	1820	2400	3000	3800
Input Current(A)		4.2/1.7	6/2.4	8.8/3.1	11.5/4.2	5.5	7.4
Condenser	Fan Power(W)	35	35	35	90	140	200
	Wind Model	Top/Side	Top/Side	Top/Side	Top/Side	Top	Top
		Finned coil air cooled condenser
Dia.of Connective Pipe(mm)		32	50	50	50	50	50
Outside Dimesion Device(mm)H×L×W		750×470×460 980×280×560	750×470×460 980×280×560	750×470×460 1050×300×620	970×760×660 900×600×850	970×760×660	970×760×660 1250×600×1000
Flew Control Device		Capillary tube/expansion valve
Evaporator		Copper coil evaporator
Refrigerant		R22
Safety Device		Motor overload\high and low voltage\water cut\low temperature
Grounding Requirement(Ω)		≤5
Insulation Resistance		1

Features:
1,This series of products adopt key parts such as high quality compressor and pumps imported from Europe ,America that makes it energy-saving and durable.
2, Using super-larger surface-area condensing coil and specially made bland blower higher heating radiation.
3, Easy installation;unnecessary to use the cooling tower.
4, Over-current relay,high and low pressure limit control,starting delay time,ready to alarm and display at any time.

Industrial water chiller for attention

1, unit run-time power supply voltage must be stable, considering all factors, blood pressure, the work crew to maintain the rated voltage of less than + -10%, voltage too high or too low are the adverse effects of the crew.

2, power frequency should be maintained at rated + -2%.

3, for the protection of human security, if the body leakage avoid the risk of electric shock, Shell should have a good crew, reliable ground fault protection device has been accidents, according to strict regulations require construction electrician.

4, transportation or move out room, do not impact with the ground, causing too much impact.

5, the room should have sufficient space for the installation and maintenance unit, taking into account the adequate space extubation.

6, the installation of the selected sites:

①, avoid direct sunlight installations or other heat source will be directly radiation areas.
②, from power nearly facilitate wiring.
③, solid ground strength, and the noise does not easily cause resonance of places.
④, placed in the house, choose a well-ventilated, humidity small, less suitable places.

7, to facilitate the discharge cooling water and chilled water, basic units must be installed around the gutter.

8, chilled water and cooling water undesirable not only led to the scaling of heat transfer, heat transfer efficiency from lower and the weakening performance unit will heat pipe corrosion caused major accidents, customers should be in strict accordance with the GB50050-1995 "Design of industrial circulating cooling water treatment norms "at the request of water treatment.

9, vertical flow switch should be installed in the outlet pipe into the pipes or the level of the paragraph.

10, flow switch to the direction of flow at least six times the pipeline diameter of straight pipe section; flow switch to the direction of flow at least four times the diameter of straight pipe pipeline paragraph; should not be installed in the near Bend, in the vicinity of the valve orifice and .

11, in order to prevent flow switch trembled, the water system should be all of the gas emissions out.

12, Australian customs regulation flowmeter, it is lower than the minimum flow of water in a state separate from the flow. When the water flow to meet the requirements, flow switch should remain closed state.

Specifications:low noise ,high reliability,low vibration,high efficiency
Export Markets:millde east; south america;africa
various compressors is used for air-conditioner as a replacement parts ,and they are high quality and excellent matching.

Member ID:
Password: