Chiller Models		LXL-57WL	LXL-93WL	LXL-160WL	LXL-240WL	LXL-310WL
Capacity	W	5699	9304	16282	23842	31168
Power	KW	2.3	3.8	7.5	11.3	15
Freezing Water Flow	L/min	40	56	80-	120	180
Inlet and Outside Pipe	Mm	φ33	φ50	φ65	φ65	φ65
Pump Power	HP	1	1	1.5	2	3
Tank Volume	L	1	1	1.5	2	3
Outside Dimesion	H×L×W mm	45	45	120	300	300
Refrigrant	R22
Power Supply	380V~3PH~50Hz
Flow Control Device	Capillary tube/expansion valve
Condenser	Shell and tube condenser
Evaporator	Shell and tube /Copper coil evaporator

Features:
1,This series of products adopt key parts such as high quality
compressor and pumps imported from Europe ,America that makes
it energy-saving and durable.
2,Equipped with special designed shell-and -tube condenser and evaporator with reinforced built-in spiral-helix line heating exchange copper coil.
3,Equipped with opened water tank,easier and quicker for cleaning and maintenance.
4,Over-current relay,high and low pressure limit control,starting delay time,ready to alarm and display at any time.
Industrial water chiller for attention

1, unit run-time power supply voltage must be stable, considering all factors, blood pressure, the work crew to maintain the rated voltage of less than + -10%, voltage too high or too low are the adverse effects of the crew.

2, power frequency should be maintained at rated + -2%.

3, for the protection of human security, if the body leakage avoid the risk of electric shock, Shell should have a good crew, reliable ground fault protection device has been accidents, according to strict regulations require construction electrician.

4, transportation or move out room, do not impact with the ground, causing too much impact.

5, the room should have sufficient space for the installation and maintenance unit, taking into account the adequate space extubation.

6, the installation of the selected sites:

①, avoid direct sunlight installations or other heat source will be directly radiation areas.
②, from power nearly facilitate wiring.
③, solid ground strength, and the noise does not easily cause resonance of places.
④, placed in the house, choose a well-ventilated, humidity small, less suitable places.

7, to facilitate the discharge cooling water and chilled water, basic units must be installed around the gutter.

8, chilled water and cooling water undesirable not only led to the scaling of heat transfer, heat transfer efficiency from lower and the weakening performance unit will heat pipe corrosion caused major accidents, customers should be in strict accordance with the GB50050-1995 "Design of industrial circulating cooling water treatment norms "at the request of water treatment.

9, vertical flow switch should be installed in the outlet pipe into the pipes or the level of the paragraph.

10, flow switch to the direction of flow at least six times the pipeline diameter of straight pipe section; flow switch to the direction of flow at least four times the diameter of straight pipe pipeline paragraph; should not be installed in the near Bend, in the vicinity of the valve orifice and .

11, in order to prevent flow switch trembled, the water system should be all of the gas emissions out.

12, Australian customs regulation flowmeter, it is lower than the minimum flow of water in a state separate from the flow. When the water flow to meet the requirements, flow switch should remain closed state.

Specifications:low noise ,high reliability,low vibration,high efficiency
Export Markets:millde east; south america;africa
various compressors is used for air-conditioner as a replacement parts ,and they are high quality and excellent matching.

Member ID:
Password: